Your furnace is a key part of your home. Without one, you wouldn’t be able to keep warm during the winter. Yet furnaces can have some issues that are more common than others.

Let’s go over these problems and discuss what they might cost to correct so you know before you contact an HVAC technician. Some of the most common furnace repair issues include:

  • Furnace won’t turn on
  • Furnace doesn’t stay lit
  • Furnace won’t blow hot air
  • Furnace won’t turn off

1. The Furnace Can’t Start

There are a couple of reasons why your furnace won’t turn on, so make sure to go through all of them.

  • Is your thermostat set correctly? Make sure it’s set to “heat,” “auto” and that your preferred temperature is greater than the room’s current temperature. If you use a programmable thermostat, make sure it has new batteries.
  • Is the circuit breaker tripped? Your furnace can’t run if it doesn’t have electricity. Reset the switch if it’s facing the outside of the electrical panel.
  • Is the furnace switch off? Your furnace has a power switch located on or close to it. Because this switch resembles a light switch, it’s easy to unintentionally turn it off. If it was off, it might take your furnace a few minutes to turn on.
  • Is the air filter clean? A dusty air filter can cause a lot of issues for your furnace. Replace yours if you can’t see light through it.

Estimated Repair Cost

This problem can be complex, so the estimated cost to repair it varies according to what’s wrong.

2. My Furnace Won’t Stay Lit

Your furnace uses a certain sequence when it begins heating your home.

  1. Your thermostat detects the temperature has fallen and tells your furnace to start running.
  2. The draft inducer fan turns on to bring in fresh air for combustion.
  3. The gas valve unlocks for the burners, which are ignited electronically.
  4. The flame sensor tells your furnace the burners have been ignited.

If something is wrong during the sequence, your furnace will shut off as a safety precaution.

A couple of potential causes for this issue include:

  • Dirty or malfunctioning flame sensor. If the sensor doesn’t detect a flame, it will shut off your furnace to prevent natural gas from spilling into your home. The ignition process corrodes flame sensors as time passes. While cleaning during annual furnace maintenance can help, yours may ultimately need to be taken out and changed.
  • Bad limit switch. This safety feature will shut off your furnace if it detects backdrafting. Backdrafting is hazardous, since carbon monoxide and natural gas can leak into your home. These switches can fail due to age, damage or dust accumulation.
  • Old thermostat. If your thermostat isn’t working properly, your furnace won’t be able to operate.
  • Dirty air filter. A dirty air filter can limit airflow and cause your furnace to shut off to prevent overheating. Make sure to replace yours every 30 to 90 days, or whenever you can’t see light through it.

Estimated Repair Cost

These costs are estimates, so it’s necessary to note yours may fluctuate based on your furnace’s brand and model.

  • Flame sensor: $350–$500
  • Limit switch: $150–$300
  • Thermostat: $150–$350
  • Furnace filter: $10-$30

3. My Furnace Is Blowing Cold Air

In many cases, this problem is tied to a wrong thermostat setting or a dusty air filter that’s restricting airflow. Use the steps above to fix the issue.

4. My Furnace Can’t Shut Down

If it’s very cold outside or you like your home to be toasty, your furnace may be running for a long time.

If this isn’t the case, make sure your thermostat is set correctly and running properly. If your fan setting is at “on,” the blower motor will be going even when the furnace isn’t, so it’ll sound like your furnace is running all the time.

Otherwise, there might be a problem with the blower motor or your ductwork may be losing air, forcing your furnace to run constantly to make up for the lost air.

Estimated Repair Cost

These costs are approximations, so it’s important to note yours may be different based on your furnace’s brand and model.

  • New blower motor: $250–$800
  • Seal ductwork: varies based on square footage

Polar Air & Mechanical Can Get to the Bottom of Your Furnace Problems Quickly and Affordably

Furnace problems can be an expensive headache, but not when you call Polar Air & Mechanical. We’ve been providing the quality, affordable furnace repair Myrtle Beach homeowners have relied on since year. Call us at 843-253-4874 to receive your free estimate today.